Analog Video Cables
We suggest using VGA to analog video cables from Monoprice. They are good quality and reasonably priced.
You can buy Monoprice component cables here
You can buy Monoprice S-video & composite cables here
You can buy Monoprice RGB/BNC cables here
Analog Video Pin out (building your own custom video cables)
If you would like to build your own custom video cables, the analog video pin out of the Nt mini is:
1 - red (also composite video, and component R-Y)
2 - green (also s-video chroma, and component luma )
3 - blue (also s-video luma and component B-Y)
4 - ground
5 - detection
6 - ground for pin 1
7 - ground for pin 2
8 - ground for pin 3
9 - nc
10 - detection
11 - ground
12 - nc
13 - H synch (also composite synch)
14 - V synch (also composite synch)
15 - detection
To make an s-video/composite cable:
1 - composite signal
6 - composite ground
2 - s-video chroma signal
7 - s-video chroma ground
3 - s-video luma signal
8 - s-video luma ground
4 - connect to 5
Use a separate ground for each signal will simplify wiring. Connecting pins 4 and 5 together will put the system into composite/s-video mode.
To make a component cable:
1 - R-Y signal
6 - R-Y ground
2 - luma signal
7 - luma ground
3 - B-Y signal
8 - B-Y ground
To make an RGB cable:
1 - Red
6 - Red ground
2 - Green
7 - Green ground
3 - Blue
8 - Blue ground
4 - connect to 10
13 - Hsynch
14 - Vsynch
11 - ground for Hsynch and Vsynch
To make a SCART cable:
See "Nt mini SCART Information.pdf" document attached to this support guide.